Top 10 Alfa Romeo 4C Headroom

Brand new 1/18 scale car model of Alfa Romeo 4C Spider Competition Red with Black Top model car by Autoart 70142

Thanks to this special watch model, you will enjoy checking the time twice as much! A solid brand clockwork ensures accuracy. The diameter of the watch is approx. 40 mm, and the water resistance is 3 ATM. We expressly point out that we, the Kiesenberg Company, are the manufacturer of the watches and that they are not produced and distributed by the vehicle manufacturers.

Brand new 1/18 scale car model of Alfa Romeo 4C Spider Bianco Trofeo/ White with Black Top model car by Autoart 70141

Brand new 1:18 scale car model of Alfa Romeo 4C Spider Giallo Prototipo Yellow with Black Top model car by Autoart 70143

The Lanzar vibe Series MOSFET amplifiers are engineered to give you uncompromised audio performance. These powerhouses are the driving force behind any great audio setup and will provide you with the sound quality and performance you’ve been missing. You’ll turn heads and be amazed by the clarity and richness of the bass production. Lanzar vibe Series amplifiers are engineered for performance and designed for the most extreme car audio enthusiasts.features:

2 x 1500 watts RMS @ 4 ohms
2 x 3000 watts Max @ 4 ohms
1 x 6000 watts Max @ 4 ohms bridgeable x 2400 watts @ 2 ohms rms
mosfet automatically switches to maintain rated
power over a wide range of battery voltages
stiffly regulated pwm-type power supplies
variable Input level controls for each pair of channels
variable high low Pass Crossover controls
high-efficiency, heavy aluminum heatsink
remote subwoofer bass control
electronic Crossover network
bass boost circuit
bridgeable at 4 ohms
2 ohm Stereo stable
silver RCA inputs
line outs for left right channels
power protection LED indicators
advanced protection circuitry
soft turn on/off
frequency response: 10hz-40khz
s/N ratio: 95db
fuse: 30A x dimensions: 10.25”W x 2.36”H x 24.41”L
sold as: unit

Power galore Two keys to unlocking great sound in a car stereo system are serious power and extensive control – and this amp’s got them both. For power, AudioControl’s DM-6.1200 6-channel amplifier puts out 125 watts RMS per channel, so it’ll drive even the most demanding aftermarket speakers with plenty of headroom to spare. And if you’re into bass, you could bridge this amp to 3-channel mode to drive three subwoofers with 400 watts RMS each, 1200 watts in total. Active controls for active systems This amp will work well with a 3-way system that uses a pair of tweeters, midrange speakers, and subs. Highly adjustable crossover networks let you set high-pass, low-pass, and bandpass filters so each driver gets only the frequencies it was designed to play. AudioControl’s AccuBASS circuit ensures maximum bass performance, even if you’re connected to a factory radio that normally turns down the lower frequencies as you turn the volume up Add kick to your factory stereo AudioControl designed the LC-6.1200 to work equally well with aftermarket and factory stereos. Eight active speaker-level inputs allow you to connect to almost any factory radio, with signal summing accommodating the separate bass, midrange, and treble signals found in some factory systems. Signal sensing circuitry turns the amp on, via the front speaker-level inputs, so you won’t need to run a remote turn-on wire throughout your vehicle. Convenient features Onboard LEDs indicate optimized signal flow for inputs and outputs, plus give you a warning when a source is too loud and causing distortion. An optional wired remote can get assigned to each and every channel pair so you can control volume from the front seat. Important Note: Some factory radios and amplifiers will not work without sensing that its speakers are connected to their outputs.